Thursday 17 October 2013

Tab Key Selection


The ‘Tab’ Key is a very good selection tool not only allowing you to cycle through your selection, but if you highlight a wall (by hovering your mouse over the element) and then hit the ‘Tab’ Key it will select all of the walls connected (Chain of Walls). This also works with Linework, etc,
(But there is more, read on)
 
 
 
An addition to this is if you select a wall and then move to another wall on the same Chain of walls, then hit the ‘Tab’ Key, it will select all of the walls in between.
Moving the cursor to the end of the wall that is closer to the chain you would like to select, and then hitting the ‘Tab’ Key will allow you to select the chain of walls (in between) you require.

 

 
 

No comments:

Post a Comment